34.10
The Priority of a Boot Device cannot be Switched
Check item
Is the switch damaged?
Is a boot media installed?
34.11
The Y Device Assigned to "Y Output Setting while
Windows is Restarting" is not Turned ON
Check item
Check if any of the following conditions is satisfied:
• Is this product changed into the Y STOP state? (Y STOP LED is ON)
• Is this product changed into the PAUSE state? (Y STOP LED is flashing)
• Has a stop error occurred? (Y STOP LED is ON)
34.12
The Y Device Assigned to "Y Output Setting when
Windows Shut Down" is not Turned ON
Check item
Check if any of the following conditions is satisfied:
• Is this product changed into the Y STOP state? (Y STOP LED is ON)
• Is this product changed into the PAUSE state? (Y STOP LED is flashing)
• Has a stop error occurred? (Y STOP LED is ON)
34 TROUBLESHOOTING BY SYMPTOM
258
34.10 The Priority of a Boot Device cannot be Switched
Corrective action
Start this product in the USB boot mode, and then check if "CFast1" is at the
bottom in the "Boot" screen of BIOS setup.
If the boot device priority is still not switched, a hardware failure may occur.
Please contact your local Mitsubishi Electric sales office or representative.
Make sure that a boot media is installed in a boot device other than CFast1.
If a boot media is not installed, install it.
Corrective action
Set the Y output status of this product to the Y OUT state. (Y STOP LED is
OFF)
Corrective action
Set the Y output status of this product to the Y OUT state. (Y STOP LED is
OFF)