Toro 02858 Installation Instructions Manual page 12

Finishing the Hydraulic
Test
Models 31657 and 31659
Installing the Brake-Pressure
Transducer
Machines with the Optional Road Light
Kit—and without the Optional Differential-Lock
Kit
1. Disconnect the test equipment from the
quick-connect fitting
2. Remove the quick-connect fitting from the
reducer fitting (Figure
Figure 32
(Figure 33).
Figure 33
34).
Note:
Retain the quick-connect fitting.
g344317
1. Reducer fitting (3/4 x 7/16
inch)
3. Assemble the brake-pressure transducer
35) into the reducer fitting (3/4 x 7/16 inch).
1. Reducer fitting (3/4 x 7/16
inch)
4. Torque the transducer to 27 N∙m (20 ft-lb).
5. Plug the 3-pin connector of the machine wire
harness labeled
the connector of the pressure transducer
g343559
36).
g344106
12
Figure 34
2. Quick-connect fitting
Figure 35
2. Brake-pressure
transducer
BRAKE PRESSURE SENSOR
g344071
(Figure
g344080
into
(Figure