Table of Contents
Advertisement
Communication options
Program communication options to set up the telephone numbers and communication formats for central station reporting. Reporting
options can be set for both system and area reporting.
PBX number (public branched exchange)
Use this option when connection to the PSTN (public switch telephone network) is made via a PBX by dialing a number sequence. For
example, you must dial 9 to get an ouside line. This feature should not be used if dial tone detection is required, as dial tone detection does
not occur during this dial sequence. If dial tone detection is required, the PBX number can be entered in the central station phone number.
1.
Press MENU, enter 1278, and press ENTER to access system programming.
2.
Enter 19 and press ENTER to access installer programming. Press MENU (advanced menu).
3.
Enter 9 and press ENTER to program communications options.
4.
If a 2-second pause P is required prior to dialing, press MENU, MENU, enter the dialing sequence required to gain access to the
outside telephone line, and press ENTER.
5.
To clear a telephone number that has been previously entered, press MENU, MENU. A P will appear on the lower line of the keypad
display and the previously entered telephone number will appear on the top line of the keypad display. Press ENTER and the
telephone number will be cleared.
Note: Do not enter a "T" (wait for dial tone) since the dial tone detection does not occur during the PBX dialing string.
MSN number (Microsoft Network)
For ISDN dialers, program a MSN number. This number is sent to the ISDN network on dialing, o a computer, or central station. To enter
a MSN number, use the same method as used for the PBX number.
Note: The MSN number can not contain a 2-second dial pause "P" or wait for dial tone "T".
Dial tone detection
This option enables or disables dial tone detection and also allows country specific dial tone detections. For operation in the USA, we
recommend that CTR21 be used. Dial tone detection will take place at the beginning of the central station dialing string when a T is
detected in the dialing string. For example, in the number 9T1234567, dial tone detection will occur before the digit 9 is dialed and again
before the 1 is dialed.
Enter the dial tone type to be detected:
0 = Disabled (no dial tone detection takes place, the panel will dial after a 2-second delay)
1 = CTR21
2 = Netherlands
3 = UK
4 = Other
New installer code
To delete, display, or create a user, do the following:
1.
Press MENU, enter 1278, and press ENTER to access system programming.
2.
Enter 14 and press ENTER to access the users programming.
3.
Enter 3 (create user) and press ENTER.
4.
Enter 50 (Installer) and press ENTER.
5.
Press MENU to list the available alarm groups that can be assigned.
6.
Press MENU again to scroll through the list.
7.
Press ENTER three times (to scroll through unneeded options) and press MENU.
8.
Enter the new code (up to 10 digits) and press ENTER.
9.
Press ENTER three times (to scroll through unneeded options).
10. Enter 0 and press ENTER to exit. The installer PIN code is now changed.
AL-2017/AL-3017 Installation Manual
15
Advertisement
Table of Contents
