Chapter 3: Performing Setup From The Control Panel; About Colorpass Setup; Making Changes To Setup; Network Server Setup Requirements - Canon Z5000 Configuration Manual

3

3-1 About ColorPASS Setup

Chapter 3:
Performing
Setup from
the Control Panel
Setup is required the first time the ColorPASS is turned on after new system software is
loaded. In this initial Setup, you (or the service technician who loads the software)
choose the language to use for ColorPASS Control Panel menus and messages.
About ColorPASS Setup
In initial Setup, you must configure at least Server Setup, Network Setup, and Printer
Setup, in that order, from the Control Panel. If you don't configure the remaining
Setups, the ColorPASS uses default settings. These defaults allow the ColorPASS to
reach the Idle state, but might not allow users to print to the ColorPASS. You need to
make settings appropriate for the printing environment at your site.

Making changes to Setup

After initial Setup, you can change Setup options from the Control Panel (page 3-2),
ColorPASS Server Setup (a Windows NT application), or the Command WorkStation
(page 4-3). Most Setup options can be set from any of these methods.
Configuring and monitoring the Windows NT functions on the ColorPASS
N :
OTE
require the Advanced Controller Interface option. For more information, contact your
authorized service/support technician.

Network server setup requirements

For Novell and Windows NT 4.0 (using TCP/IP) networks, the network servers must
be configured for printing to the ColorPASS before you configure ColorPASS network
settings in Setup. You need a live network connection so the ColorPASS can query the
network for zones, servers, and server-based queues. The diagrams on pages 1-5
through 1-9 give chapter references for network server setup.
You must configure the ColorPASS with the correct Windows NT domain name.
This is especially important for Windows printing, also known as SMB printing. For
ColorPASS systems that include the Advanced Controller option, open the Start
Menu > Settings > Control Panel > Network > Identification tab, and enter the correct
domain name. You must also check "Create a Computer Account in the Domain,"
and enter the user name and password of a user that can add workstations to the