Table of Contents
Advertisement
WEIGHT (AS SHOWN) = 560 Lbs.
3.
Clamp the mechanism in place. Lift the mechanism and set it on top of the support clamp.
Secure the mechanism to the mast with the four, square head machine bolts, two saddles, nuts
and washers. Use a 1-1/8" wrench or socket to tighten the nuts to a torque range of
95 to 105 ft-lbs.
SIG-QG-21-01
Version: A
Weight (as shown) = 461 lbs.
Recommendations for lifting pre-assembled
RECOMMENDATIONS FOR LIFTING
signals with gate mechanism:
PRE-ASSEMBLED SIGNALS WITH
GATE MECHANISM.
1) Signal assembly must be without arm and
counterweights.
1. SIGNAL ASSEMBLY MUST BE
WITHOUT ARM AND COUNTERWEIGHTS
2) Lift point should be a minimum of 15" above gate
2. LIFT POINT SHOULD BE A
mechanism.
MINIMUM OF 15" ABOVE GATE
MECHANISM.
3) Lifting sling can be used around mast and under
3. LIFTING SLING CAN BE USED
AROUND MAST AND UNDER THE
the junction box crossarm for lights as shown.
J UNCTION BOX CROSSARM FOR
LIGHTS AS SHOWN
MECHANISM ONLY CAN BE
Mechanism can only be
LIFTED INTO PLACE USING
THE LIFTING EYE PROVIDED
lifted into place using the
lifting eye provided.
Figure 4-1 Lifting Gate Assembly Recommendation
DO NOT LIFT COMPLETE GATE ASSEMBLY WITH LIFTING EYE
IN TOP OF MECHANISM HOUSING. DOING SO MAY RESULT IN
PERSONAL INJURY AND/OR DAMAGE TO THE MECHANISM.
ENTRANCE GATE INSTALLATION AND SETUP
WEIGHT = 209 Lbs.
Weight = 110 lbs.
WARNING
4-3
NOVEMBER 2021
Advertisement
Table of Contents
