8.14. Warm air sensor (TH3), Sensor
U (TH1,TH2), Discharge air
hose and Exhaust air hose
8.14.1. Replacement of Warm air sensor
(TH3)
1. Upon completion of procedures 1 through 6 of the Fan
case U (8.6.1), pull out the Sensor built-in cord seal
rubber.
Because the cord seal rubber is Sleeve, you can take it
easily.
8.14.2. Replacement of Sensor U
(TH1,TH2)
Go to the procedure for Replacement of Drying heater (8.6.2).
1. Remove 3 Tapes and 2 Clamping bands.
2. Remove the 6 Heater cover B fixing screws.
3. Pull out 2 Sensor U (TH1, TH2) built-in cord seal rubbers
to complete replacement.
Because the cord seal rubber is Sleeve, you can take it
easily.
43
NA-D106X1