Table of Contents
Advertisement
Solid-state drive
Description
1-TB, 2280, PCIe, 3×4, NVMe, 3LC, 1 side, SN solid-state drive
512-GB, M.2, 2280, NVMe solid-state drive supporting TLC
256-GB, M.2, 2280, NVMe solid-state drive supporting TLC
Before removing the solid-state drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1.
Remove the Phillips PM1.0×2.5 screw (1) that secures the bracket to the computer.
2.
Remove the bracket (2).
3.
Slide the solid-state drive away from the connector to remove the drive (3).
Reverse this procedure to install the solid-state drive.
30
Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
26).
Spare part number
908359-002
855609-001
855608-001
Battery on page
28).
Advertisement
Table of Contents
