Nokia 6500 SLIDE RM-240 Service Manual page 80

• Oscilloscope
• Function generator (sine waveform)
• 'Active speaker' or 'speaker and power amplifier'
• Sound level meter
• Current probe (Internal handsfree DPMA output measurement)
• Phoenix service software
• Battery voltage 3.7V
Test procedure
Audio can be tested using the Phoenix audio routings option. Three different audio loop paths can be
activated:
• External microphone to Internal earpiece (XMICEAR)
• External microphone to Internal handsfree speaker (XMICIHF)
• Internal microphone to External earpiece (XMICEAR)
Each audio loop sets routing from the specified input to the specified output enabling a quick in-out test.
Loop path gains are fixed and they cannot be changed using Phoenix. Correct pins and signals for each test
are presented in the following table.
Phoenix audio loop tests and test results
The results presented in the table apply when no accessory is connected and battery voltage is set to 3.7V.
Earpiece, internal microphone and speaker are in place during measurement. Applying a headset accessory
during measurement causes a significant drop in measured quantities.
The gain values presented in the table apply for a differential output vs. single-ended/differential input.
Loop test
External Mic to
External Earpiece
Page 3 –36
Input Output
terminal terminal
XMICP and HSEAR R P,
GND HSEAR R N
and GND
HSEAR P,
HSEAR N
and GND
XMICN and HSEAR R P,
GND HSEAR R N
and GND
HSEAR P,
HSEAR N
and GND
COMPANY CONFIDENTIAL
Copyright © 2007 Nokia. All rights reserved.
BB Troubleshooting and Manual Tuning Guide
Path Input
gain [dB] voltage
(fixed) [mVp-p]
-2.9 1000
Differential Output
output DC level
voltage [V]
[mVp-p]
720 1.2
RM-240
Output
current
[mA]
NA
Issue 1