HP EliteDesk 705 G2 MT Hardware Reference Manual page 33

8. Slide the drive into the drive bay, making sure to align the mounting screws with the guide slots, until
the drive snaps into place.
9. Connect the power cable (1) and data cable (2) to the rear of the hard drive.
10. If installing a new drive, connect the opposite end of the data cable to the appropriate system board
connector.
NOTE: You must connect the primary hard drive data cable to the dark blue connector labeled SATA0
to avoid any hard drive performance problems. If you are adding a second hard drive, connect the data
cable to one of the light blue SATA connector labeled SATA1 and SATA2.
11. Replace the computer access panel.
12. Reconnect the power cord and any external devices, and then turn on the computer.
13. Lock any security devices that were disengaged when the access panel was removed.
Removing and Installing drives 27