HP ZBook Studio G4 Maintenance And Service Manual page 44

4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1. Remove the Phillips PM2.0×3.5 screw (1) that secures the solid-state drive to the system board.
NOTE:
dictated by the spring mechanism.
When installing the module, be sure to insert the module at the angle that it sits after the screw is
removed and the module springs up.
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
32 Chapter 5 Removal and replacement procedures for authorized service provider parts
Bottom cover on page
If the module springs up when the screw is removed, be sure to remove the module at the angle
29).
Battery on page 41).