Kenwood TK-290 Service Manual page 16

3-5. Clone Mode
1. Connect the cloning interface cable between the master
side transceiver (source) and slave side transceiver
(clone) as shown in the figure.
Cloning interface cable
Part No. E30-3325-05
2. Set the master side transceiver to Self programming
mode, and the transceiver display to "CLONE" with the
[Top 1] key or [Top 2] key and press [PTT].
[Top 1] [Top 2]
SEL CHAN
3. Set the power switch on the slave side transceiver to
ON.
4. The red LED on the master side transceiver flashes when
cloning starts and an "END" message appears when
cloning ends.
5. The green LED on the slave side transceiver flashes.
6. When a problem occurs during cloning, an "ERROR"
message appears on the master side transceiver.
7. Pressing the [Side 2] key sets clone mode.
Note :
The master transceiver copies only to type matched
slave.
• All Clone
1. Press [PTT] on the master side transceiver to start clon-
ing of all data except for the transceiver model type and
alignment data.
A CLONE
Red lamp flashes
REALIGNMENT
CLONE
[PTT]
A CLONE
[Top 1]
[Top 2]
G CLONE
[PTT]
END
• Group Clone
1. To clone the transceiver group data and channel data
within the group, as well as group alphanumeric data, use
the [Top 1] key or [Top 2] key to switch the display on the
master side transceiver from "A CLONE" to "G
CLONE".
[Top 1] [Top 2]
A CLONE
2. Press [PTT] to show the group cloning selection.
3. Select the group with the [Top 1] or [Top 2] keys.
4. Press [PTT] to show the slave side group cloning selec-
tion.
5. Select the group with the [Top 1] or [Top 2] keys.
[PTT]
G CLONE GRP 1M
6. Press the master side [PTT] to start cloning.
[PTT]
GRP 1S
Red lamp flashes
• Flow Chart
Self programming mode
Clone master mode
[PTT]
[ ] [ ] ··· [#]
All clone/group clone selection
[Side 2]
[PTT]
[Top 1]
[Top 2]
All clone mode
[Side 2] [PTT]
END
[Side 2]
Only the keypad model and
*
set to password with the FPU.
TK-290
G CLONE
[PTT]
GRP 1S
END
[Top 1] [Top 2]
[PTT] [Side 2]
* Clone lock
[Side 2]
[PTT]
* Password input
[Side 2]
[Side 2]
[PTT]
Group clone mode
[Side 2]
[PTT]
"Master" group selection
[PTT] [Side 2]
"Slave" group selection
[Side 2]
[PTT]
[Side 2]
15