Table of Contents
Advertisement
TCD300E(e).book Page 36 Tuesday, October 12, 2004 8:22 PM
SMS (Short Message Service)
8
Press {ih}.
Receiving a message
When an SMS message is received:
– a tone is heard (if the ringer is turned off,
this tone is not heard)
– "Receiving SMS Message" is
displayed
– h is displayed
– the total number of new (unread) SMS
messages is displayed next to h if the
screen saver (page 12) is turned off
Reading a received message
1
Press $ (middle soft key).
2
Select X, then press ,.
3
To access the public mailbox
Select "Public", then press ,.
To access a private mailbox
Select the desired mailbox, press ,,
then enter its password.
L If a mailbox contains new (unread)
SMS messages, @ is displayed next to
the total number of messages for that
mailbox.
4
Select "Receive List", then press
,.
5
Press {e} or {v} repeatedly to select a
message.
L Messages which have already been
read are indicated by a Q, even if they
were read using another handset.
L To erase a message, press w,
select "Yes", then press ,.
6
Press , to read the message
content.
Note:
L To call the message sender, press {C}
or {s}.
36
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
L If "SMS Full" is displayed, new SMS
messages cannot be received. Erase
unnecessary messages (page 35, 36).
L If you receive a message from a party
saved in the phonebook, the stored name
is displayed.
L Some SMS service providers attach a 1-
digit number to the message sender's
phone number, and sender names stored
in the phonebook may not be displayed as
a result.
Replying to a message
1
While reading a received message,
press $ (middle soft key).
2
Select "Reply", then press ,.
3
Enter a message (page 39), then press
,.
4
Edit the destination phone number
and/or press ,, then continue from
step 7, "Writing and sending a new
message", page 34.
Editing/forwarding a message
1
While reading a received message,
press $ (middle soft key).
2
Select "Edit Message", then press
,, then continue from step 5,
"Writing and sending a new message",
page 34.
Erasing received messages
1
While reading a received message,
press $ (middle soft key).
2
Select "Erase", then press ,.
L To erase all messages in the selected
mailbox, select "Erase All", then
press ,.
3
Select "Yes", then press ,.
4
Press {ih}.
Advertisement
Table of Contents
