Fastening The Base; Figure 2-12 Fastening The Base Of Bts3606A - Huawei Airbridge BTS3606 Installation Manual

Installation Manual – BTS3606A Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station

2.3.5 Fastening the Base

To fasten the base, proceed as follows:
1) Disassemble the cabling rack, rodent-resistant plate and anti-slip plate.
2) Put the base on the cement plinth.
3) Match the holes at the bottom of the base with those on the plinth.
4) Level the cabinet by adding washers under the base.
5) Fasten the base on the plinth using M12 x 70 bolts, spring washer, big plain
washer, and square taper washer.
The fastening base of BTS3606A cabinet is shown in Figure 2-12, and that of
battery cabinet is shown in Figure 2-13.
(1) Cement plinth
(5) Big plain washer 12

Figure 2-12 Fastening the base of BTS3606A

Chapter 2 Installing Cabinet Base or Channel Steel
(2) Base (3) Washer
(6) Spring washer 12
Huawei Technologies Proprietary
2-10
(4) Square taper washer 12
(7) M12 x 70 bolt