Panasonic EH-TSW5E Operating Instructions Manual page 8

How to Use
(continued)
3
Attach the water supply
plate to the main unit.
# Hold so that the protruding part of the
knob is facing upward.
$ Set the water supply plate under the
water supply plate attachment clasps
(2 pc) on the main unit.
% Push the knob in from above until you
hear it click into place.
If there is a lot of water on the water
supply plate, water drops may splash
when attached.
When not using the
4
Set the aroma tablet in the
aroma holder.
As shown in the illustrations, hold the aroma
tablet by the grip and insert it into the aroma
holder from below.
• Push it in all the way.
With the aroma tablet, the strength of the scent can be selected according to
whether the tablet is set with the front or back facing up.
• For a stronger aroma, insert it into the aroma holder with the front side facing your
nose.
Front (scent strength: strong)
Stop using the aroma tablet if its scent make you feel queasy or you should sense
something wrong.
5
Press the power/temperature switch and select a temperature.
Temperature of the temperature sensitive area :
LOW: Approx. 38 °C
HIGH: Approx. 40 °C
Glows blue
Power
OFF LOW HIGH LOW HIGH
Every time the power is turned on, it starts at the LOW mode.
The temperature may change accordingly to the environment temperature.
(When the room temperature is 25 °C, it will take about two minutes for you to feel heat.)
EN13
# Protruding
part
$
%
, skip to step 5.
Back (weak)
6
Press the vibration switch and select
the desired vibration.
The massager can be used without vibration when only
Clasp
heat and not vibration is desired.
Even if vibration is switched on during use, it switches off
automatically after about 6 or 12 minutes.
Vibration
indicator lamp
Click
Explanation of vibration settings
◆Vibration 1: A loose and weak vibration (approximately 12 minutes)
Very slow
Click
Approximately
2 minutes
◆Vibration 2: Vibration switching frequently between strong and weak
Small
difference
between strong
and weak
Approximately #
1 minute
# Large difference between strong and weak:
approximately 1 minute ⇒ slow: approximately 12 seconds
$ Large difference between strong and weak:
approximately 1 minute ⇒ slow: approximately 6 seconds
% Large difference between strong and weak:
approximately 1 minute ⇒ slow: approximately 30 seconds
◆
V ibration 3 (QUICK) : Some variation between strong and weak
(approximately 6 minutes)
Large difference
Slow
between strong and weak
Approximately
1 minute
The main unit makes a small sound (a clicking sound) when in the vibration operation.
This does not indicate a problem.
7
Attach the main unit.
Close your eyes.
Place the appliance so that the
temperature sensitive area (P. EN7) is at
the position shown in the illustration.
Vibration 1 Vibration 2 Vibration 3
(QUICK)
Slow Very slow Slow
Approximately Approximately Approximately
2 minutes 2 minutes 2 minutes
(approximately 12 minutes)
Small
difference
between strong
and weak
$ $ $ % Approximately
1 minute
Monotonous
Slow
vibration
Approximately Approximately Approximately
3 minutes 1 minute 1 minute
Vibration
OFF
Monotonous
Very slow
vibration
Approximately Approximately
2 minutes 2 minutes
Large
Monotonous
difference
Slow
between strong
vibration
and weak
Approximately Approximately Approximately
1 minute 1 minute 2 minutes
EN14
Continued on P. EN15