11. Addresses (Cont.)
Setting Addresses
(Setting the address of the indoor unit)
1. Set the address for the remote controller following the
procedure under the section "Setting Remote Controller
Addresses" (see page 17).
2. Press [Emergency Operation]
seconds or longer.
When you do this, the lamps of the display will blink one after another.
3. Press
on the remote controller.
4. The buzzer will sound and the address of the indoor unit will
change to the address displayed on the remote controller.
5. If you press [Emergency Operation]
the lamps on the indoor unit's display will turn off.
Notes
• Please do not hold the [Emergency Operation]
while the indoor unit's display lamps are blinking one after another.
• Make sure to operate while the indoor unit is stopped.
• The address of indoor unit is set to "ALL" at the time of the shipment.
Wireless
remote
controller
address
display
Address
Address
Receiving is
switch
possible at all
position
address
positions
Interruptor
ON/OFF
Address
1
ALL
of the indoor unit for 4
of the indoor unit once,
button of the indoor unit down
Address
Address
2
3
Address
Address
4
5
Address
6
18
(EN)