Table of Contents
Advertisement
Notice Before Use
If
This means that:
The pot is not placed in the center of the correct cooking zone.
●
When the pot is an unsuitable size or is not magnetic (e.g., aluminum pot) or some other small
●
objects (such as knives, forks and keys) are placed on the top plate.
* The appliance automatically enters the standby mode with no operation for 1 minute. (all
displays show "-" and "- -", and the displays will automatically turn off in 1 minute.) The fan will
continue to dissipate heat for several minutes.
* No heating takes place unless there is a suitable pot on the cooking zone.
Please adjust the heat level according to the materials you are cooking.
●
Setting the heat level to 5 or less for pre-heating may avoid overheating of the pot.
●
Otherwise, oil temperature may rise rapidly and cause a fire.
➜
When it is necessary to heat for a long time and shut down automatically, please use the timer
●
(see EN15).
Auto shut-down is a safety feature for the appliance.
Automatic power-off will be activated when the cooktop is used for 2 hours even if you forget to
turn off the cooking zone.
* If the pot is removed or an unsuitable pot is placed on the top plate,
1 minute and it beeps. After the flashing stops, it will enter the standby mode. The display will
automatically turn off in 1 minute.
Notes
People with a heart pace maker should consult with their doctor before using this appliance.
●
Preparation
●
➜
●
➜
●
➜ Otherwise, the air intake at the bottom of
and heat level indication flash alternately
Cooking tips
Auto shut-down
Place a pot in the center of the cooking
zone and make sure that the bottom
diameter of the pot is larger than 12 cm.
Otherwise, the cooking zone will not work
normally.
Before cooking, wipe off water from the
top plate and pot.
Otherwise, the cooking zone cannot detect
the temperature of the pot bottom correctly.
Do not place and use this appliance on thin
sheets (such as plastic adhesive taps or
paper).
the appliance may be blocked, causing
poor heat dissipation and activate
overheating protection.
will be displayed after
EN11
Advertisement
Table of Contents
