Table of contents Page
7
General.................................................................................................................................................26
8
System design information .................................................................................................................27
9
Assembly..............................................................................................................................................30
10
Installation .......................................................................................................................................32
10.1
10.2
10.3
10.3.1
10.4
Stand-alone operation .........................................................................................................36
10.5
Relay outputs........................................................................................................................37
10.6
Inputs.....................................................................................................................................38
10.6.1
R - input .........................................................................................................38
10.6.2
P - terminal.....................................................................................................38
10.6.3
10.6.4
Input (Eing) ....................................................................................................38
10.6.5
...................................................................................................................38
11
Commissioning...............................................................................................................................39
11.1
Analog loop...........................................................................................................................40
11.2
11.3
12
Specifications..................................................................................................................................44
If used properly, the "IQ8Wireless transponder (Part No. 805595)" complies with
the basic directives and corresponding requirements in according to the R&TTE
Directive 1999/5/EC.
The EC conformity statement can be downloaded at www.novar.de.
Additional and updated Informations
The described features, specifications and product related informations in this
manual correspond to the date of issue (refer to date on the front page) and may
differ due to modifications and/or amended Standards and Regulations of the
System design, Installation and Commissioning.
Updated documentations and informations are available for comparison on the
www.novar.de homepage.
EU-Community requirements
This RF-device has been developed, manufactured and labeled in accordance to
the requirements of the European Union (EU). If this device should be installed
outside this EU directives and respectively in Italy (I), Norway (N), Cyprus (CY),
Poland (PL), Slovakia (SK), Croatia (HR) or Romania (RO), the valid standards
and requirements of the appropriate country must be observed and satisfied.
Commissioning of this device is only permitted in accordance to the national and
local standards and requirements.
FB 798941 / 10.06
IQ8Wireless transponder for wall mounting
25