Download Print this page

Whirlpool 215WP User Manual page 4

Advertisement

Massage bathtub
6. 6 Ch ec k wh et he r ha ve br ea k on pi pe an d wa ter wa y ap er iod ical ly.
6. 7 Pl ea se che ck wh et he r the re is fal l off or br ea kag e on wi re, swi tch, con ne ctor pl ug s so tha t rep ai r
in time.
6. 8 In or de r to kee p to us e in a lon g ter m ,pl ea se reme mbe r, do n' t us e mor e tha n 3 ho ur s con tinu el y.
7、Fault eliminate
Fault
Voltage unstable
Power connector didn't connect
well or open circuit
Machine or equipment
The windpipe connect air switch
doesn't work
fall off or break
The air switch failure
Power's parameter is not same as
nameplate
Big nose of machine
Fixed screw did'n fix or fall off
Support's leg screw did not touch
ground
water pipe leak out
The joint did not fix well
Water pipe or accessory leak
Remark: except this fault, please according to situation to resolve, or find
experienced people to repair.
8、special remind
8.1 please find qualified people to install bathtub according to introduction.
8.2 when you are using it, first of all you have to inject the cold water and then inject the
hot water. Don't inject the hot water first.
8.3 bathtub's machine must connect on ground, support must use 1.5mm yellow/green
double wire connect with ground and check whether effective.
8.4 please do not turn on machine without water, before draining should turn off machine.
8.5 children should be looked after in bathtub.
8.6 bathtub's temperature cann't higher than people average temperature, and the best
is 32-37centigrade.
8.7 after shower ,please cut off power.
8.8 if have these situation ,please do not enter into massage bathtub.
8.8.1 younger than 4 years old's child;
8.8.2 blood circulation unstabled people;
8.8.3 sot;
8.8.4 suffer from flu;
8.8.5 heart disease;
8.8.6 already have sauna;
8.8.7 after meal in half a hour;
Remark: our company has the right to modify the above mention without further notice.
Way
Cause
Check circuitry
Insert again or change
power line
Connect again or change
Change
Connect with supplier
Fix tightly again
Adjust
Aging
Change
Fix again
Change
2
Page 3 of 7
Bathtub User's Guide
WARNINGS
1. Please follow the instruction contained in the attached installation
manual to ensure that the product is installed properly.the manuf-
acturer will not be held liable for damages or injuries caused by im-
proper installation.
2.Follow the instructions contained in this manual when using the product.
3. Before using the bathbub, check the local voltage that if reach to the
rated voltage(pre-installation card).
CONTENTS
I. Safety Precautions
II. Brief Introduction
III.Operation of Control Panel
IV.Precautions for Installation and Use
Massage bathtub
Page 4 of 7

Advertisement

loading