Default Settings - D-Link DWL-810 User Manual

Connections
Rearview
Ethernet Port – an RJ-45 jack
provides connection to a network
device using a Cat 5 Ethernet
cable. (Use Straight-Through
CAT5 cable when connecting to
another Ethernet adapter, like the
port in a gaming device; use a
Cross-Over CAT5 cable when
connecting to a switch.)
Reset Button – press this button to revert to the factory default settings of
the DWL-810
Power Connector – connect one end of the included 5V DC Power Adapter
into the power port on the DWL-810 and connect the other end of the Power
Adapter to a wall outlet.
Category 5 is the most reliable grade of twisted-pair cable. It is either Straight-
Through cable or Cross-Over cable.
instructions to make sure that you have selected the correct type of Category 5
cable. For the DWL-810, you will use Straight-Through cable to connect to the
computer during configuration and to connect to a network device for wireless
sharing. Use a Cross-Over cable to connect to a switch.

Default Settings

Operating Mode
SSID
Channel
Transmission rates
WEP enable
Administrator password
IP Address
IP Subnet
username
Reset Button
Power Connector
Ethernet Port
(MDIX)
Always check your installation
Ad -Hoc
default
6
Auto
No
Blank (no password needed)
192.168.0.30
255.255.255.0
admin
6