Table of Contents
Advertisement
Warnings and cautions when using
Viewfinder high voltage
Do not open the viewfinder cover.
danger
of
touching
components.
Power supply
The specified power supply input voltage of this
camera is 12VDC. Be sure to use the designated
power supply.
Do not disassemble or modify
The
camera
contains
components.
Do not open the cover or disturb
switches and controls other than designated.
There is risk of impaired performance and
damage.
Keep foreign object out of interior
Entry of water, metallic or other foreign materials
can cause failure and damage.
Select use and storage locations carefully
Avoid using or storing the equipment in the
following
types
of
performance and damage can be caused.
Extremely hot or cold locations (exceeding -10 to
45°C), such as in enclosed vehicles.
Subject to strong vibration.
Humid or dusty locations.
Salt spray or corrosive gases.
Strong electromagnetic fields (e.g., near TV or
radio transmitters).
Where exposed to rain.
NOTE
**********CCD characteristic phenomena**********
The following types of phenomena are innate characteristics of a charge coupled device (CCD) and are
not malfunctions. Be aware of these when using a CCD camera for broadcast or other demanding
applications.
There is
internal high voltage
precision
internal
locations.
Impaired
Smear
When a bright object is picked up, thin trails appear above and below the
image.
The effect is more pronounced at high electronic shutter speeds.
Fixed pattern
When operate at high temperature, a fixed pattern (vertical stripes,
white dots) can appear. The pattern is more easily seen when the
camera sensitivity is raised.
Do not cover or otherwise obstruct camera heat
dissipation during operation.
When
connecting
microphone and other cables, grasp the connector
by the body, not the attached cable. Cables can be
damaged by pulling on them.
Note when transporting
When transporting by hand, use the carrying
case. If shipping by truck or other means, pack
in the carrying case, then use further cushioning
and pack in a sturdy carton.
Cleaning
Use a photographers air blower to clear dust from
the lens and filters. Wipe the case with a soft
dry cloth. Do not use volatile solvents, as these
may deform the materials.
In event of difficulty
Disconnect from power and contact the nearest
Hitachi Kokusai Electric service agency.
2
and
disconnecting
lens,
Hide quick links:
Advertisement
Table of Contents
