Electrical Connection - Miele Connector Box Operating And Installation Instructions

Disconnect the Miele Professional ma-

chine from the mains voltage.
Attach the Connector Box box to the wall

using the 4 screws (4 x 40) and plugs (S6)
provided. See Fig.  in the "" chapter.
Alternatively, the Connector Box box can

be attached to the wall using the adhesive
strips provided. See Fig.  in the
"" chapter.
Establish the connection between the

Connector Box box and the Miele Profes-
sional machine and the external hardware
(e.g. payment system).
When connecting external hardware
provided by other manufacturers, the cable
cross-section must not be less than
2
1.0 mm with a maximum cable length of
2.50 m (98 ¹/₃").
Mounting the cable strain relief
The connection cables of external hardware
must be fastened to the Connector Box box
using cable glands and cable strain relief
fixtures. See Fig.  in the "" chapter at
the end of these operating and installation
instructions.
Remove the lid from the Connector

Box box (remove the 2 screws).
Remove one or more of the cable strain

relief fixtures a.
Stand the Connector Box box on its nar-

row end so that the sealed connection
holes are at the top.
Using a screwdriver, press out the round

indentation in the connection hole b.
Tip: Pierce through the groove round the
edge at several places using a screwdriver.
Insert the counter nut c.

Screw on the threaded fitting d.

Tip: Slide the screw cap e over the end of
the connection cable for the external hard-
ware.
Guide the connection cable through the

threaded fitting and into the Connector
Box box.
Tighten the screw cap.

The screw cap provides protection against
moisture and dust.
Secure the connection cable with the

strain relief f.
Make the required connections for the ex-

ternal hardware in the Connector Box box.
Close the lid on the Connector Box box

(screw in the 2 screws).
Key for cable strain relief in Fig.  in the
"" chapter
a Cable strain relief fixtures
b Connection hole
c Counter nut
d Threaded fitting
e Screw cap
f Cable strain relief with screws
Configuration
Once the Connector Box box has been in-
stalled, the settings for the external func-
tions have to be made on the corresponding
Miele Professional machine.
Follow the instructions provided in the op-
erating and installation instructions for the
Miele Professional machine.
To enable communication with external
hardware (payment system, dispensing unit,
etc.), settings/configurations need to be
made on the Miele Professional machine.

Electrical connection

The Connector Box box is supplied with
mains voltage by the Miele Professional ma-
chine.
The Connector Box box does not have an
additional On/Off switch.
en - English
35