Trimming Outboard Motor; Adjusting Trim Angle For Manual Tilt Models - Yamaha F13.5B Owner's Manual

Operation
4. Remove the key if the boat will be left
unattended.
NOTE:
The engine can also be stopped by pulling
the cord and removing the clip from the en-
gine shut-off switch, then turning the main
switch to " " (off).
EMU27861

Trimming outboard motor

The trim angle of the outboard motor helps
determine the position of the bow of the boat
in the water. Correct trim angle will help im-
prove performance and fuel economy while
reducing strain on the engine. Correct trim
angle depends upon the combination of
boat, engine, and propeller. Correct trim is
also affected by variables such as the load in
the boat, sea conditions, and running speed.
EWM00740
WARNING
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make
steering the boat more difficult. This in-
creases the possibility of an accident. If
the boat begins to feel unstable or is hard
to steer, slow down and/or readjust the
trim angle.
38
ZMU02041
1. Trim operating angle
EMU27872
Adjusting trim angle for manual tilt
models
There are 4 or 5 holes provided in the clamp
bracket to adjust the outboard motor trim an-
gle.
1. Stop the engine.
2. Tilt the outboard motor up, and then re-
move the trim rod from the clamp brack-
et.
1. Trim rod
3. Reposition the rod in the desired hole.
To raise the bow ("trim-out"), move the rod
away from the transom.
To lower the bow ("trim-in"), move the rod to-
ward the transom.
Make test runs with the trim set to different
angles to find the position that works best for
1
ZMU05601