Page 1
Attaching your DeWalt deep cut band saw to the Vertikut stand Unplug the saw and remove the blade. Remove the cutting guide from your saw by removing the two flathead screws that hold it on. Take the assembled stand and find the two counterbored holes in the table top.
Page 2
WARNING!!!! Read and understand the entire contents of this sheet before attempting set-up or operation of this equipment • This product is designed and intended for use by properly trained and experienced personnel only. If you are not familiar with the proper safe use of hand band saws, DO NOT USE THIS PRODUCT UNTIL PROPER TRAINING AND KNOWLEDGE HAS BEEN OBTAINED.