Page 1
Set-Up Instructions Set-Up Instructions Thank you for purchasing Canon imageCLASS MF3110. To get your machine ready for use, please follow the instructions in this document before referring to any other documentation. Unpack the machine and its components. Check that you have the following: ●...
Install the cartridge. 1 Remove the cartridge from the bag. Keep the bag in a safe place for future use. 3 Hold the cartridge on a flat stable surface with ➊ one hand, and break the tab ➋ the seal completely with the other hand.
Page 3
Assemble the cassette and load paper. 1 Insert the output tray into the front slot on the machine. 3 Attach the extension to the cassette. The slots ➊ are keyed and must be inserted at a 90° angle. Once inserted, fold the extension as shown ➋.
Page 4
5 Load the paper into the cassette. Make sure the paper stack sits below the hooks (A). 7 Even out the edges of the paper stack. Make sure the height of the stack does not exceed the limit marks side edges of the stack are below the hooks (B).
Connect the power cord. 1 Plug the power cord into the rear socket ➊. Then connect the other end to the wall outlet ➋. 2 The machine takes up to 3 minutes to warm up. Once it is warmed up, the standby display appears in the LCD.
Install the software. IMPORTANT Do not connect the USB cable before installing the software. If you connect the USB cable before installing the software ● and the Found New Hardware Wizard screen appears, click [Cancel] and disconnect the USB cable. NOTE The instructions below are for Windows XP.
Page 7
On the MF Setup screen, click [Install MF Toolbox]. When the MF Toolbox Setup screen appears, click [Next] and follow the instructions on the screen. NOTE Before installing MF Toolbox, make sure that all other ● applications are closed and that any anti-virus software on your computer is disabled.