Monitor And Select Events - HP StreamSmart 410 User Manual

Figure 3-7
An Events-with-Entry Setup
In Figure 3-7, C2 is highlighted as the destination for data from the sensor in
Channel 2 of the StreamSmart 410. Pressing !sgsy]!!CHK! now will deselect Channel 2
for exporting data. Pressing the CHOOS menu key drops down a list of C1 through
C9, and C0, from which you can choose any other column for the data from the
sensor in Channel 2.
In Figure 3-8, the EVENT METHOD field is highlighted, showing that With
Entry has been selected. You may choose to have the events auto-numbered or
skip adding any numerical entries to the events (Event Only). Press the CHOOS
menu key to make a selection from these three options, as shown in Figure 3-9.
Figure 3-8 Event Method Field Figure 3-9 Event Method Options
Press $OK% to accept all your changes at any time, or the CANCL menu key to
cancel all changes; either way, you will return to the Numeric view.

Monitor and select events

Once you have activated the proper channels and set destinations for the data
from these channels, you are ready to begin collecting data. Of course, you can
always just start by collecting data using the default columns. To capture an event,
just press the $ADD# menu key. If you have selected to capture events only, or to
have them auto-numbered, you will see a display similar to the one depicted in
Figure 3- 1 0, which shows that your event data are being added to the current data
set. If you have selected to add events to your entry, the display will appear as
shown in Figure 3- 1 1, prompting you to add your numerical entry to the event just
captured.
Figure 3- 1 0 Event Only Figure 3- 1 1 With Entry
Capturing Data from Events
25