Sony DSBK-160 Installation Instructions Manual page 16

Installation
3
4
16
Take up the slack in the cables by inserting them first into
the cable holder on the left, then the cable holder on the
right, then again into the cable holder on the left, as shown
in the figure (left and right are as seen from the rear of the
DSR-70/70P).
Cable
holders
From connector panel
Notes
• When winding the cables around the cable holders, do not
pull them tight. Loop them loosely through the cable
holders as shown in the figure.
• Make sure that the cables do not pass over or under any
board levers.
Place the SDI-38 board above the opening where the
battery panel was removed, and connect the cables to the
board. Attach the red, orange, and yellow cables to their
respective RED, ORG, and YEL connectors on the board.
RED: red cable
ORG: orange cable
YEL: yellow cable
Wind the wire clip around the cables.
To SDI-38 board