Toro Sand Pro 3040 Service Manual page 208

Testing the Traction Neutral Switch (continued)
Electrical System: Testing the Electrical Components
6. There should be continuity across the switch terminals when the traction
pedal is in the N
EUTRAL
7. Slowly push the traction pedal in the forward or reverse direction while
watching the multimeter. There should be no continuity across the switch
terminals in either the forward or reverse position.
8. Allow the traction pedal to return to the neutral position. There should again
be continuity across the terminals when the pedal returns to N
9. Replace the switch if necessary.
10. If the switch tests correctly and a circuit problems still exists, test the machine
wire harness; refer to
11. Connect the switch to the wire harness and install the center shroud.
12. Operate the machine and test the traction neutral switch operation before
returning the machine to service.
position.
Appendix A (page A–1).
Page 6–18
.
EUTRAL
Sand Pro ® 3040 and 5040
20251SL Rev A