Advertisement
This LED flashes yellow if the module is receiving data via the serial interface from the
device for which recordings are to be made.
6| Send LED
This LED flashes blue if the module is sending data via the serial interface to the device
for which recordings are to be made.
7| Serial interface
This is where to connect to the module the device for which recordings are to be made.
Use the original connecting cable for this purpose. The serial interface is galvanically
separated, thus it is recommended one use cables whose shielding is severed on one
side so as to prevent a galvanic connection of the shields via the housing.
4 Establishing the connection
The SegoConnect Module Advanced has a total of three connectors. Establishment of the
connection between device and network takes place in three simple steps:
Step 1:
Establish the network connection using the network cable (Connector 2).
When the power LED lights up blue your network has PoE functionality and
you do not need to carry out Step 3.
Step 2:
Connect the serial interface (Connector 7) with the device for which
recordings are to be made. For this purpose it is best, if possible, to switch
off the device for which recordings are to be made.
Step 3:
If your network is not PoE-ready (see Step 1), connect the module to the
mains (Connector 3) using the mains power adapter provided. As soon as
the module receives power the blue power LED will light up.
The configuration of the SegoConnect module in the network is done via UDP.
6 | 9
Advertisement
