Installing Hp 3Par Os Files - HP 3PAR StoreServ 7450 Service Manual

e. Specify the speed and duplex and press Enter.
Please specify speed (10, 100 or 1000) and duplex (half or full), or auto to
use autonegotation: auto
NOTE:
f. Type the NTP system IP address and press Enter.
g. If you indicated more than one IP address, the setup script prompts you to choose which
nodes to use for each address. Note, <X Y Z> are nodes (for example: 2 3 for nodes
2 and 3).
Enter config for IP #0
IP Address: <IPaddress>
Netmask: <netmask>
Nodes Using IP address: <X Y Z>
h. Verify the IP address information is correct. Type y and press Enter.
16. The OOTB has completed when the following displays:
Out-Of-The-Box has completed.
Please continue with the SP moment of birth.
Exiting Out-Of-The-Box Experience...

Installing HP 3PAR OS Files

After completing the Service Processor Setup wizard process, HP 3PAR OS files must first be
installed onto the SP in order to communicate and add a storage system.
NOTE: Note: If the StoreServ is previously setup before the SP, do not use the SP Setup Wizard.
Beginning with HP 3PAR Service Processor Software 4.1.0 MU2, the SP Setup Wizard expects
the StoreServ to be in a non-initialized state. As a result, use SPMOB (SP console) method to set
up the SP. The SPMOB allows you to ignore StoreServ verification failures during SP setup because
the SmartStart SP Setup Wizard prevents the bypassing of the verification operation.
To install the OS files:
1. Insert the HP 3PAR OS Release Distribution CD into the SP.
2. Log in to the SP as spvar (password prompted).
3. In the SPMaint main menu, type:
1 for SP Control/Status
16 for Maintain SP Software
1 for Update SP Software Revision
2 for CDROM to install the files.
NOTE:
4. When prompted to update the SP, verify that the software version is correct. Type y and press
Enter to continue with the update process.
Mounting CDROM...
Using spinstaller from /sp/sw/sp/2.5.1.GA-15/
54 Installing Storage Software Manually
If an NTP system IP address is not provided, use the SP IP address.
The installation process takes approximately five minutes.