Siemens CP 1626 Operating Instructions Manual page 41

"Module information"
Depending on the selected level, the table shows information on the PC station, the DP
master system, the PNIO master system, the nodes, the individual communications
processors or even the modules or submodules of the station.
"Display of the module levels"
Via the links, you go to the "Module information" of the higher module levels.
"Details"
With the "Details" link, you obtain further information on the selected communications
processor in the "Status" and "Identification" tabs.
"IP address"
If a link is available here, this will bring you to the Web server of the selected and configured
I/O device.
"Topology"
The two web pages, "Topology" and "Module information", are linked. A click on "Topology"
of the selected communications processor automatically takes you to this communications
processor in the graphic view of the the set topology on the "Topology" Web page. The
communications processor appears in the visible area of the "Topology" web page and the
device head of the selected communications processor flashes for a few seconds.
"Status" tab
This tab contains information on the status of the selected communications processor if there
is a fault or a message pending.
"Identification" Tab
This tab contains data to identify the selected communications processor.
Note
In this tab, only data that was configured offline is displayed, but no online data of
communications processors.
CP 1626
Operating Instructions, 11/2018, C79000-G8976-C434-03
Operating hardware
4.3 Web server
41