Miele WTS 510 Fitting Instructions Manual page 38

38 von 86
NOTE
A
Remove the shipping struts.
Drawer installation
A
Place the drawer on the rails inside the stand and close it.

The drawer will audibly lock into place.
A
To ensure that the drawer is correctly positioned on the rails, open it again and slam it shut.
Front panel adjustment
The machine front and the front panel of the drawer must be in line with each other. After installation, it may be
necessary to adjust the drawer front panel to align it. The height and tilt angle of the drawer front panel can be adjusted.
A
Open the drawer.
A
Adjust the height of the front panel:
– Remove the cover (A); see Fig. 13.
– To adjust the height, turn the adjustment wheel in the direction of the arrows as appropriate (B).
– When the height has been adjusted appropriately, reinstall the cover.
A
Adjust the tilt angle of the front panel:
– To adjust the angle, twist the drawer rods as appropriate; see Fig. 14.
A
Close the drawer.
When installing machines next to each other: Connect the stands
A
Place the stands next to each other.
A
Loosen the counter nuts on all stand feet.
A
Twist out the connection pieces.
A
Place the connection pieces with their openings on the stand feet but don't secure them with the counter nuts yet.

The two connected stands must align with each other at the front.
Stand feet adjustment
A
Use a level.
A
Adjust the stand feet as appropriate until the stand is level; see Fig. 15.
A
Multiple-stand combinations: Ensure that all stands are the same height.
A
Tighten all counter nuts.
en-US
es
Zócalo con cajón para lavadoras y secadoras: WTS 510
Piezas necesarias:
Número Nº de mat. Denominación
1 09322300 Juego de montaje WTS 510
28.09.2018 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 09469886