Plate Bottom Assy - Sony SRS-ZR7 Service Manual

SRS-ZR7
2-6.

PLATE BOTTOM ASSY

Note 1: Lay a soft piece of cloth under the unit
to avoid damaging the top panel.
adhesive sheet
(plate bottom)
5 Insert your finger in the crevice
between the plate bottom assy and the
cabinet, and while peeling off the
adhesive surface, remove the
plate bottom assy carefully.
14
1 two cushions (foot)
2 two screws
(BTTP M2.6 8)
3 two foot
4 Insert two screwdrivers into
the hole, and lift the plate
bottom assy slightly.
Note 2: The screwdriver is inserted between the
2 two screws
(BTTP M2.6
plate bottom assy and chassis, then lift
the plate bottom assy.
screwdriver
plate bottom assy
bracket (PWB MAIN)
chassis
6 plate bottom assy
Note 3: When removing this parts, it is not re-used to deform.
If this parts is deformed, replace it with new parts.
When replacing the plate bottom assy, peel the serial label
on the plate (bottom) carefully, and stick the serial label to
the new plate (bottom) (Refer to the figure below).
old plate (bottom)
8)
1 two cushions (foot)
2 two screws
(BTTP M2.6 8)
3 two foot
bottom side
front side
serial label
new plate (bottom)