Advertisement
7
After insertion of USB Drive into reader slot a firmware upgrade information window will appear as
shown in Figure5.
8
If the window is no present, remove the USB Drive and try reinserting the USB Drive again.
9
Press the "left or right arrow" buttons on the remote controller to select the "Yes".
Press the "OK" button on the remote controller.
Following message will appear in sequence of figure 6 and 7.
10
Press the "left or right arrow" buttons on the remote controller to select the "Yes".
11
Press the "OK" button on the remote controller to start the Software updating.
Copyright 2010
Figure5
Figure6
Figure7
All Rights Reserved
Page 3 of 4
Advertisement
