Required parts
• Rack mount rail (RMM-30)
Rail with bracket
Screw (B5 X 8)
• Screw for inner rail (B4 X 8)*
• Screw for rack mounting (RK5 X 16) : 4 pcs.
• Washer for rack mounting
(Sony part number: 2-297-913-01)
* : The BDX-E1000 comes with the eight screws. The
two screws of them are spare.
c
Be sure to use the RMM-30 rack mount rail.
If a rack mount rail other than the RMM-30 is used, the
BDX-E1000 may be dropped by insufficient strength of
the rack mount rail. This may cause a injury.
Procedures
1. Turn the power off.
2. Remove the four feet from the bottom of the BDX-
E1000.
Feet
BVTT 3·12
BDX-E1000
: 2 pcs.
: 8 pcs.
: 6 pcs.
: 4 pcs.
Feet
BVTT 3·12
3. While pressing the stopper of the rail, pull out the
inner rail.
Outer rail
4. Attach the inner rails to the BDX-E1000 using the six
screws (B4 X 8) supplied with the BDX-E1000.
B 4×8
5. Loosen the screws fastening the rear bracket to the
outer rail, and adjust the position of the rear bracket
with the rack depth.
Rear bracket
Outer rail
1-4. Rack Mounting
Stopper
Inner rail
Inner rail
Inner rail
B 4×8
Front bracket
1-3 (E)