Smms, Mini-Smms, Smms-I, Shrm, Shrm-I Series - Toshiba RBC-EXW21E2 Quick Reference

SMMS, MiNi-SMMS, SMMS-i, SHRM. SHRM-i Series
<RBC-AMT21E>
4
6
1
5
Procedure
When pushing the
display section flashes and after a short period of time the following confirmation code should be displayed [
1
• When the item code is one other than [
eliminate the display and then repeat the procedure from the first step.
(The remote controller operation is not accepted for approx. 1 minute
after pushing the
(In a group control, the indoor unit with its number displayed first is set to
the header unit.)
For every push of the
Select the indoor unit of which setup is to be changed.
2
In this time, the fan and louver of the selected indoor unit will operate allowing you to
identify the position of the indoor unit of which the setup is to be changed.
Using the
3
Using the
4
Priority:
Push the
5
lighting.
After setup operation has finished, push the
6
When pushing the
to the usual stop status.
(The remote controller operation is not accepted for approx. 1 minute.)
(NOTE)
Only one indoor unit can be set to "Priority". If the multiple indoor units are
accidentally set to "Priority", an error code (L05 or L06: Duplicated indoor
unit priority) is displayed.
To the unit displaying "L05", [0001 (Priority)] is setup. Separate a unit which
you will give priority from the other indoor units, and return the setup data
of the other indoor units to [0000 (No priority)].
Error code
L05 Indoor unit priority duplication ([
L06 Indoor unit priority duplication ([
<RBC-AMT31E>
SET DATA
TEMP.
3
4
2
FILTER
RESET TEST
3
6
+ + buttons at the same time for 4 seconds or more, as shown in the figure, the
button.)
, the indoor unit numbers in the group control are successively displayed.
buttons, specify the item code [
buttons, select the setup data [
, No priority:
button. In this time, the setup operation finishes when the display changes from flashing to
button, the display disappears and the status returns
Error contents
CODE No.
SETTING
UNIT No.
R.C. No.
ON / OFF
TIMER SET FAN MODE
TIME SWING/FIX VENT
5
SET CL UNIT
1 2
Operation contents
], push the button to
].
].
button. (Setup is determined.)
] is set up.)
] is set up.)
– 46 –
<RBC-AMT32E>
SET DATA SETTING
UNIT No.
R.C. No.
TEMP. ON / OFF
3
TIMER SET FAN
4
TIME SAVE
FILTER
RESET TEST SET CL SWING/FIX UNIT LOUVER
6
1
<RBC-AMT21E button>
1
, and
2
3
and
4
and
5
6
<RBC-AMT32E button>
2
UNIT LOUVER
CODE No.
MODE
VENT
5
2
].