Bosch AXT Rapid 2000 Original Instructions Manual page 4

OBJ_BUCH-2380-003.book Page 4 Thursday, March 1, 2018 3:38 PM
4 | English
If the machine becomes clogged,

switch off and allow the cutter to
stop. Remove the plug from the
mains supply before clearing debris.
Check if guards and protective devic-

es are undamaged and properly
mounted. Before using, carry out any
necessary maintenance and repairs.
Clean the cooling air outlet grid from

outside, using a vacuum cleaner to
clear the dust and debris which inevi-
tably builds up there. The filter mesh
cannot be removed.
Never pick up or carry the machine

while the motor is running.
Whenever you leave the work area,

switch off, allow the cutter to stop,
and remove plug from the mains sup-
ply.
Do not tilt the machine while it is run-

ning.
Do not expose the machine to rain.

Only store the machine in a dry place.
When using an aggregator then it

needs to be an Automatic Voltage
Regulation (AVR) version avoiding
damages caused by overvoltage
spikes. Aggregator minimum power
need to be 4 kW.
Maintenance and Storage
When the machine is stopped for ser-

vicing, inspection, or storage, or to
change an accessory, switch off and
remove the plug from the mains sup-
ply and allow the machine to cool.
Make sure that all moving parts have
come to a complete stop before mak-
ing any inspections, adjustments,
etc.
F 016 L81 414 | (1.3.18)
Maintain the machine with care and

keep it clean.
Examine the machine and replace

worn or damaged parts to maintain
its safety.
Ensure replacement parts fitted are

Bosch-approved.
If an extension cord is used with the

machine, see paragraph "Electrical
Safety".
When servicing the cutter (e. g. turn-

ing over the blade, or replacing it), be
aware that there is no brake on the
motor and so the blade can be moved
by hand and could trap fingers, etc..
Never attempt to override the inter-

lock feature of the hopper.
Electrical Safety
Warning! Switch off, remove
plug from mains before ad-
justing, cleaning or if cable is
cut, damaged or entangled.
Your machine is double insulated for
safety and requires no earth connec-
tion. The operating voltage is 230 V AC,
50 Hz (for some non-EU countries
220 V, 240 V as applicable).
For increased electrical safety use a Re-
sidual Current Device (RCD) with a trip-
ping current of not more than 30 mA.
Always check your RCD every time you
use it.
Supply cord. If your appliance is in-
tended for use in the UK, it may have a
ready-fitted supply cord, fitted with a
UK 3-pin plug approved to BS1363/A
(this has a 13A fuse fitted). Inspect the
cord regularly for damage. If damaged,
Bosch Power Tools