Viewing Channel Fader Settings - Yamaha 02R96 Owner's Manual

Output Channels
This is the Parameter View page for the Bus Outs, Aux Sends, and the Stereo Out. Parame-
ters are the same as for the Input Channel Parameter View page, minus the GATE and Phase
sections and the DELAY MIX and FB GAIN parameters. The parameter settings of the left
and right channels of the Stereo Out can be viewed individually. Use the [SEL] buttons to
toggle between the left and right channels.

Viewing Channel Fader Settings

The fader-related settings of the currently selected Input Channel, Bus Out, Aux Send, or
the Stereo Out can be viewed and set on the Fader View pages.
1 Use the DISPLAY ACCESS [VIEW] button to select the Fader View page.
Use the LAYER buttons to select Layers, and use the [SEL] buttons to select
2
channels.
Use the cursor buttons to select the parameters, and use the Parameter
3
wheel, INC/DEC buttons, and [ENTER] buttons to set them.
Pan and Balance controls can be set to center by pressing [ENTER] while they're selected.
Input Channels
This is the Fader View page for the Input Channels.
PAN: This is the currently selected Input Channel's Pan parameter. See "Panning Input
Channels" on page 67 for more information.
ON/OFF: This is the On/Off parameter of the currently selected Input Channel. See "Mut-
ing Input Channels (ON/OFF)" on page 63 for more information.
Fader: This indicates the fader position of the currently selected Input Channel. The fader
knob appears highlighted when the fader is set to 0.0 dB. The fader position is displayed
Viewing Channel Fader Settings
02R96—Owner's Manual
109