General Information; Updating The Musiccast Server Firmware - Yamaha MCX-2000 Owner's Manual Addendum

7

Updating the MusicCAST Server Firmware

CAUTION
Do not disconnect the power cable while this unit is in the firmware update procedure.
Follow the procedure below to update the firmware on this unit. You need to perform the firmware update in advance to
use the new features in the firmware update.
1
Select "Top Menu" > "Setup" > "System Utilities" >
"System Update".
The following display appears in the OSD.
Setup
Use this utility to update the MCX-2000 firmware.
Step 1 : Insert the system update CD
Step 2 : Push the > key to open the Submenu
Step 3 : Select "Start"
Cancel
2
Press OPEN/CLOSE on the front panel (or the remote
control), and then load the firmware update CD with
its label side facing up.
STANDBY/ON
POWER
STAMDBY/ON
AMP/TV
TV AMP
TIMER OPEN/CLOSE
TV
RANDOM REPEAT BROADCAST RADIO
1 2 3
TIMER OPEN/CLOSE
4 5 6
7 8 9
0 TOP PLAU
MENU INFO.
PAGE A
SELECT
PAGE Z
VOL. INPUT
RANDOM REPEAT
BOOLMARK
AMP/TV
MUTE
LIBRALY ARTSTS PLAULISTS
MENU 1 MENU 2 MENU 3
FAVORITES
1 2 3 4
Remote control
3
Press OPEN/CLOSE on the front panel (or the remote
control) to close the CD tray.
This unit starts reading the data of the update CD,
and then the following display appears in the OSD.
Setup
Use this utility to update the MCX-2000 firmware.
Step 1 : Insert the system update CD
Step 2 : Push the > key to open the Submenu
Step 3 : Select "Start"
Cancel
MCX-2000 Owner's Manual Addendum for Version 2
4

General Information

System Utilities
System Update
No update CD present
AMP
BROADCA
System Utilities
System Update
Update CD is ready
Submenu
4
Push the center stick rightward on the front panel (or
press > on the remote control) to open the Submenu,
and then select "Start".
The OSD disappears, and the following screen
appears in the front panel display.
SYSTEM UPDATE
n
It takes about 20 minutes to update the firmware of the server.
5
When the following message appears in the front
panel display, press OPEN/CLOSE on the front panel
(or the remote control) to open the CD tray, and then
unload the firmware update CD.
SYSTEM UPDATE SYSTEM UPDATE
UPDATE OK
EJECT CD AND RESTART
6
Press STANDBY/ON on the front panel (or the remote
control) twice to reboot this unit.
n
Once this unit reboots, select "Top Menu" > "Setup" > "System
Utilities" > "System Information" > "Version" to make sure the
version of the firmware of this unit is 2.0 (or later).
n
If the firmware update fails, an error message appears in the
front panel display. In such cases, try the firmware update
procedure again. If the same error message appears in the front
panel display again, consult with an authorized YAMAHA
service center.