Huawei OptiX RTN 980 Quick Installation Manual page 42

3
Crimp the joint parts of the bare crimp terminal and
the conductor of the power cable by using a crimping
tool.
NOTE
The shapes of the crimped parts may vary according to the types of crimping dies.
CAUTION
Do not heat the heat shrink tube for a very long time to avoid damage to the insulation layer.
b
Assembling Cord End Terminals and Power Cables
• Components of a cord end terminal and a power cable
A
C
39
4
Push the heat shrink tube A towards the connector until
the heat shrink tube covers the crimped parts of the bare
crimp terminal and the conductor of the power cable.
Then, heat the heat shrink tube by using a heat gun.
B
Wire stripper
Crimp pliers for the
cord end terminal