5
4
6
4. Install:
• EXUP valve pulley cover
EXUP valve pulley cover bolt
10 N·m (1.0 kgf·m, 7.4 lb·ft)
EAS31145
CHECKING THE FRONT BRAKE LIGHT
SWITCH
Refer to "ELECTRICAL COMPONENTS" on
page 8-38.
EAS31146
ADJUSTING THE REAR BRAKE LIGHT
SWITCH
TIP
The rear brake light switch is operated by the
movement of the brake pedal.
Adjustment is correct when the brake light
comes on by depressing the brake pedal 5.5–
12.0 mm (0.22–0.47 in) or more.
1. Check:
• Rear brake light operation timing
Incorrect → Adjust.
2. Adjust:
• Rear brake light operation timing
a. Hold the main body "1" of the rear brake
light switch so that it does not rotate and
turn the adjusting nut "2" until the rear
brake light comes on at the proper time.
2
EAS31147
CHECKING AND LUBRICATING THE
3
CABLES
The following procedure applies to all of the in-
ner and outer cables.
EWA13270
Damaged outer cable may cause the cable to
corrode and interfere with its movement. Re-
place damaged outer cable and inner cables
as soon as possible.
1. Check:
• Outer cable
2. Check:
• Cable operation
TIP
Hold the cable end upright and pour a few drops
of lubricant into the cable sheath or use a suit-
able lubricating device.
EAS30815
CHECKING THE THROTTLE GRIP
1. Check:
• Throttle grip movement
TIP
With the engine stopped, turn the throttle grip
slowly and release it. Make sure that the throttle
grip turns smoothly and returns properly when
released.
1
Repeat this check with the handlebar turned all
the way to the left and right.
EAS30816
CHECKING AND CHARGING THE BATTERY
Refer to "CHECKING AND CHARGING THE
BATTERY" on page 8-42.
EAS30662
CHECKING THE FUSES
Refer to "CHECKING THE FUSES" on page
8-41.
3-35
PERIODIC MAINTENANCE
WARNING
Damage → Replace.
Rough movement → Lubricate.
Recommended lubricant
Engine oil or a suitable cable lu-
bricant
Rough movement → Lubricate or replace the
defective part(s).
Recommended lubricant
Suitable cable lubricant