Steps
1. Insert a flat-head screwdriver in the hole of the bracket for optional I/O module.
2. Push the bracket to release the bracket from the system chassis.
3. Connect the I/O card cable to the connector on the system board.
4. Insert the I/O card into its slot from the inside your system.
5. Use the two (M3x3) screws to secure the optional I/O card to the chassis.
NOTE:
The screw type differs with the kind of I/O module used.
Next steps
1. Install the
riser
card.
2. Install the
hard drive
assembly.
3. Install the
front
bezel.
4. Install the
top cover (side
5. Install the
side
cover.
6. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
56
Disassembly and reassembly
bezel).
after working inside your
before working inside your
computer.
computer.