Canon imagePRESS Server F200 Installation And Service Manual page 11

I
NTRODUCTION
• When connecting or disconnecting the power cord:
– Only use the power cord that shipped with the imagePRESS Server or an appropriate
replacement power cord available from an authorized provider.
– Always disconnect the power cord from the imagePRESS Server connector panel before
opening the unit and servicing internal components.
– Do not pull on the power cord when unplugging the imagePRESS Server. Instead, pull
the plug.
– Do not place objects on the power cord. Place the power cord away from foot traffic.
– Do not tamper with or disable the power cord grounding plug.
– Do not use a 3-prong adapter in a 2-hole, ungrounded outlet.
– Do not use an extension cord.
– Do not plug the imagePRESS Server into a circuit with heating or refrigeration
equipment (including water dispensers).
– Do not plug the imagePRESS Server into a switchable power outlet. This can result in
the imagePRESS Server being turned off accidentally.
• Never set any liquid on or near the imagePRESS Server or the copier. If liquid is spilled into
the imagePRESS Server or the copier, disconnect the power cord immediately.
• Do not attempt to open the power supply, DVD drive, or hard disk drive.
• Handle the imagePRESS Server LCD window with care.
If the imagePRESS Server LCD window breaks and the liquid crystal inside leaks out, avoid
contact. If you come in contact with the liquid crystal, immediately wash it off your skin with
soap and water.
• Use care when handling parts of the imagePRESS Server, as some edges on the unit may be
sharp.
• Do not install third-party applications onto the imagePRESS Server. Third-party applications
are not supported and can cause system problems. Although virus scans are permitted on the
imagePRESS Server, antivirus software should not be loaded in memory-resident mode.
• Do not change the Windows operating system software preference settings.
Depending on the changes made, the imagePRESS Server may become unstable or even
unusable. If this occurs, we recommend that you reinstall the imagePRESS Server System
Software, which reliably restores the Windows operating system software to its factory
defaults.
• Never alter an existing network without permission.
The imagePRESS Server will probably be connected to an existing Local Area Network
(LAN) based on Ethernet hardware. The network is the link between the customer's
computer, existing laser printers, and other prepress equipment. Never disturb the LAN by
breaking or making a network connection, altering termination, installing or removing
networking hardware or software, or shutting down networked devices without the
knowledge and explicit permission of the system or network administrator or shop supervisor.
11