Changing Internal Interface Configurations
Configuration settings are stored in a part of memory called an EEPROM
("Electronically-Erasable Programmable Read-Only Memory"). Information
3
stored in the EEPROM remains intact even when your controller is turned off.
Follow these instructions to enter and use 110 Configuration Mode.
1
With this power-up display on
your monitor, type:
2
This Configuration Control
menu will appear.
Enter the I/O Configuration
Mode by typing:
Copyright 1991
He~lett-Packard
Company
All Rights Reserved
BOOTROH Rev. 3.01 2 HAY 91
HC68040 Processor
Configuration EEPROM
Utility Chip at 41
HP-HIL.Keyboard
DMA-CO
Configuration Control
Keys
Control Class
1
I/O Configuration
2 Auto System Selection
A Abort
~ithout
changes
Type [key] RETURI ?
3-2
Configuring Internal Interfaces and Boot Modes