Huawei USG6000 Series Hardware Manual page 242

HUAWEI USG6000 Unified Security Gateway
Hardware Guide
Step 3 Install the new hard disk unit. The installation methods for 1 U and 3 U models are the same.
For details, see
Step 4 Run the disk online command and then the display disk information command in the system
view. If Filesystem Status is Mounted, the hard disk works properly.
----End
Adding the Hard Disk
The USG6650/6660/6670/6680 series supports dual hard disks. Do as follows to add a hard
disk on the USG, which has been running for some time with a single hard disk:
Step 1 Ensure that all configurations are saved.
Step 2 Run the disk offline command in the system view. Wait about 30 seconds until the system
indicates that the hard disk stops working, remove the filler panel from the hard disk slot, and
install a new hard disk unit.
Issue 03 (2015-01-26)
Figure 3-4 Removing the hard disk unit (USG6650/6660/6670/6680)
Installing the Hard Disk
For dual hard disks, Filesystem Status becomes Mounted several hours after the disk online command
is run. During this period, you can use other services, but the hard disks do not record real-time logs for
these services. After data synchronization completes, the hard disks automatically start to work. You can
run the display disk information command in the user view on the next day to check whether
Filesystem Status is Mounted. If not, contact EdgeWave technical support personnel.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Unit.
3 Maintaining the Hardware
232