System service mode (PRISMAsync service mode)
Introduction
The system service mode is the Service Diagnostic System (SDS) as available on the PRISMAsync
controller.
The SDS is used by the FST to configure, diagnose, backup and restore settings, for the print
engine, accessories and PRISMAsync controller.
System service mode (PRISMAsync service mode)
No.
Function
1
[Service Copy Mode]
This button is used to temporarily switch to Normal mode. In this mode printing and
scanning is possible. You can re-enter SDS without the need of the PIN.
NOTE
Printing must be stopped before re-entering Service mode
System service mode (PRISMAsync service mode)
Additional
Chapter 4 - Using the PRISMAsync
4
39