Advertisement
Quick Links
Doc. 16.90.00
Toyota
Yaris
Part Number: 00016-05463
Accessory Code: ME4000
Note: This accessory requires replacement A-Pillar clip
62217-52070 to complete the installation for this vehicle.
This accessory requires small wire harness cover
00016-05463-04 to complete the installation for this
vehicle.
Conflicts
Factory HomeLink
Note:
Kit Contents
Item #
Quantity Reqd.
1
1
2
1
5
1
Hardware Bag Contents
Item #
Quantity Reqd.
1
2
2
2
3
10
4
3
5
2
Additional Items Required For Installation
Item #
Quantity Reqd.
1
1
1
1
Recommended Tools
Safety Tools
Safety Glasses
Special Tools
Installation Tools
Needle Nose Pliers
Screw Gun
T20 Torx Bit/Driver
#2 Phillips Bit
Nylon Tool
Wire crimping tool
Side cuts
Dark Towel/ Cloth
Special Chemicals
Southeast Toyota Distributors, LLC.
Business Partner: J79
2015
Description
Frameless® Mirror w/Compass
& HomeLink®
Wire Harness Cover
Main Power Wire Harness
Description
Red T-Taps
Red Spade Connectors
Wire Ties
Foam Tapes
Quick Reference Guides
Description
A-Pillar Clip (62217-52070)
Small Wire Harness
Cover (00016-05463-04)
10mm Socket
Torque Wrench-48inch lbs
(Car Battery)
Ratchet/Driver
PIO / DIO
Frameless® EC Mirror w/ Compass & HomeLink®
Service Part Numbers
Part Description
Frameless® EC Mirror w/Compass
and HomeLink®
Main Power Wire Harness
Small Wire Harness Cover
A-Pillar Clip
General Applicability
Recommended Sequence of Application
Item #
Accessory
1
2
3
Page 1 of 22
08/18/15
Part Number
00016-05463-01
00016-05463-02
00016-05463-04
62217-52070
*Mandatory
REV.D.8.12.15
Advertisement
Related Manuals for Toyota ME4000
Summary of Contents for Toyota ME4000
- Page 1 Yaris 2015 Frameless® EC Mirror w/ Compass & HomeLink® Part Number: 00016-05463 Accessory Code: ME4000 Note: This accessory requires replacement A-Pillar clip 62217-52070 to complete the installation for this vehicle. This accessory requires small wire harness cover Service Part Numbers...
- Page 2 Isolate the cable with protection in place. See Figure 1. Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. Figure 1 Southeast Toyota Distributors, LLC. Page 1 of 21 REV.D.8.12.15...
- Page 3 Detach the 2 claws and remove the visor holder. See Figure 2. Figure 2 3. Using a nylon tool, disengage the 4 clips. Disconnect the connector. Remove map light assembly. See figure 3. Figure 3 Southeast Toyota Distributors, LLC. Page 2 of 21 REV.D.8.12.15...
- Page 4 This item must be ordered separately. Note: RH front A-Pillar garnish is shown in figure 5. Use the same procedure for the LH front A-Pillar garnish. Figure 5 Southeast Toyota Distributors, LLC. Page 3 of 21 REV.D.8.12.15...
- Page 5 See figure 6. Figure 6 7. Disengage the 2 claws and remove the outer mirror switch assembly/knock out. See figure 7a and 7b. Vehicles without Switch-Remove knock out. Figure 7b Figure 7a Southeast Toyota Distributors, LLC. Page 4 of 21 REV.D.8.12.15...
- Page 6 22 inches from the end of the spade connectors and ring terminal. Pull/Separate the ground wire from the main power harness approximately 6 inches. See figure 9a and 9b. Figure 9a Figure 9b Southeast Toyota Distributors, LLC. Page 5 of 21 REV.D.8.12.15...
- Page 7 Using the new spade connector provided, connect the black and black/white tracer wires to one connector. Make sure the wires and spade connector have made a good connection. See figure 11. Figure 11 Southeast Toyota Distributors, LLC. Page 6 of 21 REV.D.8.12.15...
- Page 8 Figure 12a Figure 12b 13. Route the mirror harness to overhead console opening using the precut notches on the front of the headliner. See figure 13. Figure 13 Southeast Toyota Distributors, LLC. Page 7 of 21 REV.D.8.12.15...
- Page 9 Figure 14a Figure 14b 15. Connect the mirror harness to the mirror main power harness. Make sure both connectors are fully engaged. Wrap foam tape around conectors. See figure 15. Figure 15 Southeast Toyota Distributors, LLC. Page 8 of 21 REV.D.8.12.15...
- Page 10 (1) piece of foam tape. See figure 16. Figure 16 17. Route mirror main power harness along front edge of headliner towards the LH vehicle A-Pillar. See figure 17. Figure 17 Southeast Toyota Distributors, LLC. Page 9 of 21 REV.D.8.12.15...
- Page 11 DO NOT wire tie the mirror harness to the airbag. Figure 18 19. Route the mirror harness down to the outer mirror remote switch. Follow the factory harness. See figure 19. Figure 19 Southeast Toyota Distributors, LLC. Page 10 of 21 REV.D.8.12.15...
- Page 12 T-Tap the main power harness power wires to Pin 8 grey wire in white connector D105. T-Tap the main power harness ground wire to Pin 7 white/black wire in white connector D105. Figure 20a Figure 20b Southeast Toyota Distributors, LLC. Page 11 of 21 REV.D.8.12.15...
- Page 13 See figure 21. Figure 21 22. Engage the clips and install the No. 2 instrument panel finish panel. See figure Figure 22 Southeast Toyota Distributors, LLC. Page 12 of 21 REV.D.8.12.15...
- Page 14 Hint: Tape the needle-nosed pliers tip before use. Note: RH front A-Pillar garnish is shown in figure 24. Use the same procedure for the LH front A-Pillar garnish. Figure 24 Southeast Toyota Distributors, LLC. Page 13 of 21 REV.D.8.12.15...
- Page 15 25. Use the same procedure for the LH front A-Pillar garnish. Figure 25 26. Engage the 4 claws to install the map light assembly. See figure 26. Figure 26 Southeast Toyota Distributors, LLC. Page 14 of 21 REV.D.8.12.15...
- Page 16 Toyota Yaris Frameless® EC Mirror w/ Compass & HomeLink® 27. Engage the 2 claws. Push in the visor holder as shown in the illustration. See figure 27. Figure 27 Southeast Toyota Distributors, LLC. Page 15 of 21 REV.D.8.12.15...
- Page 17 Yaris Frameless® EC Mirror w/ Compass & HomeLink® 28. Place owner’s cards in the glove box. See figure 28. Figure 28 29. Connect the negative battery cable. Torque: 48in.*lbf Figure 29 Southeast Toyota Distributors, LLC. Page 16 of 21 REV.D.8.12.15...
- Page 18 NOTE: Correct compass zone must be selected prior to compass calibration to ensure accurate calibration. If the vehicle is driven in a new zone, repeat zone selection procedure. Figure 30 Southeast Toyota Distributors, LLC. Page 17 of 21 REV.D.8.12.15...
- Page 19 Map Light Assembly: flashing. Verify the map light functions properly. Check map light. Remote Mirror Switch, Interior Light Dimming Switch. Check the remote mirror switch, interior Verify switch functions properly. light dimmimg switch. Southeast Toyota Distributors, LLC. Page 18 of 21 REV.D.8.12.15...
- Page 20 D105. IMH1 IMH1 Frameless® EC Mirror w/Compass and HomeLink® SET P/N 00016-05463-01 IMH1 T-Tap the main power harness ground wire to Pin 7 white/black wire in white connector D105. D105 Southeast Toyota Distributors, LLC. Page 19 of 21 REV.D.8.12.15...
- Page 21 Pin 3 to ground Approx. 12 VDC with switch in ON position Approx. 0 VDC with switch in OFF position Wire Color Circuit Black w/White Trace Ignition Black Ground Black Ignition Southeast Toyota Distributors, LLC. Page 20 of 21 REV.D.8.12.15...
- Page 22 Toyota Yaris Frameless® EC Mirror w/ Compass & HomeLink® Vehicle Connector D105 Circuit Southeast Toyota Distributors, LLC. Page 21 of 21 REV.D.8.12.15...