Information On The Display Panel; Faults And What To Do About Them - Siemens WM Series Instruction Manual And Installation Instructions

Faults and what to do about them.

en

Information on the display panel

Display
YES
NO
E:16
E:17
E:29
A: 10
E:18
E:23
²»
Other displays
Faults and what to do about them.
Faults
Water is leaking from the
appliance.
The appliance is not filling
with water.
Detergent is not being dis-
pensed.
The door cannot be
opened.
The programme does not
start.
22
Cause/remedial action
The washing machine door is unlocked. It is possible to add laundry.
Due to the high temperature in the drum, the washing machine door cannot
■
be opened. Wait until the temperature drops.
Due to the high level of water in the drum, the washing machine door can-
■
not be opened. Drain the water (e.g. select the Spin or Empty programme (if
only a drain cycle is required, set rpm (spin speed) to $ Rinse hold = 2
without final spin selected ).
Laundry may become trapped. Close the washing machine door properly.
Turn on the cold water tap fully
■
Supply hose kinked or trapped
■
Water pressure too low. Clean the filter in ?
■
Turn on the hot water tap fully, supply hose kinked or trapped.
■
Supply hose kinked/trapped; water pressure too low. Clean the filter.
■
Hot water hose not connected; washing machine is operated using cold
■
water only. Ignore the message; this message is only displayed for the first
wash cycle.
Detergent solution pump blocked. Clean the detergent solution pump.
■
Drain hose/waste pipe blocked. Clean the drain hose on the siphon.
■
Water in the base trough due to appliance leaking. Call after-sales service.
If childproof lock is active, deactivate it.
Switch off the appliance, wait for five seconds and switch it back on again. If the
display appears again, call after-sales service.
Cause/remedy
Attach the drain hose correctly or replace it.
■
Tighten the threaded joint on the inlet hose.
■
Start button not selected?
■
Is the tap turned on?
■
Could the filter be clogged? Clean the filter ~ Page 21.
■
Is the inlet hose kinked or trapped?
■
The safety function is activated. Stop the programme?
■
$ Rinse stop = 2 without final rinse selected? ~ Page 11.
■
Can the door only be opened by the emergency release? ~ Page 21.
■
Start button for a pause or "Ready in" time pressed?
■
Is the door closed?
■
Childproof lock active? Deactivate.
■