Siemens SINUMERIK 840Di Diagnostic Manual page 409

11/2006
22290 Channel %1 spindle operation for transformed spindle/axis %2 not
possible (reason: error code %3).
Parameters: %1 = Channel number
%2 = Axis name, spindle number
%3 = Error code
Definitions: It is impermissible to start a spindle as long as it is used by a transformation. Reason: spindle usage
in a transformation requires axis operation which must not be exited.
This alarm may have the following reasons:
- Error code 1 : M3, M4 or M5 per synchronized action;
- Error code 2 : M41 through M45 per synchronized action;
- Error code 3 : SPOS, M19 per synchronized action;
- Error code 11 : DBB30 spindle stop;
- Error code 12 : DBB30 spindle start clockwise rotation;
- Error code 13 : DBB30 spindle start counterclockwise rotation;
- Error code 14 : DBB30 spindle positioning.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Resolve the conflict, for example by deactivating transformation prior to spindle start.
Program Clear alarm with the Delete key or NC START.
Continuation:
22320 Channel %1 block %2 PUTFTOCF command could not be transferred
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The cyclic transfer of the PUTFTOCF data block (fine tool compensation) could not be performed
because the transfer area is already occupied.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Check the part program, in particular with regard to the other channels. Is a data block being
transferred by another channel?
Program Clear alarm with the RESET key. Restart part program
Continuation:
22321 Channel %1 axis %2 PRESET not allowed during traverse motion
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A preset command was given from MMC or PLC while an axis was traveling in JOG mode.
Reaction: Interface signals are set.
Alarm display.
Remedy: Wait until the axis is stationary.
Program Clear alarm with the Delete key or NC START.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-409