Operating Modes; Preparing Hard Drives For Video Recording - Bosch DIVAR IP all?in?one 5000 Series Installation Manual

DIVAR IP all-in-one 5000
–
–
–
–
4.3

Operating modes

The DIVAR IP system can operate in three different modes:
–
–
–
Notice!
Recorded video streams need to be configured in a way that
the maximum bandwidth of the system (BVMS/VRM base
system plus iSCSI storage expansions) is not exceeded.
4.4

Preparing hard drives for video recording

Systems that come pre-equipped with hard drives from factory
are ready to record out-of-the-box.
Hard drives that have been added to an empty system need to
be prepared (formatted) before using them for video recording.
Bosch Security Systems B.V.
DIVAR IP needs to have an active network link during
installation. Make sure that the network switch you are
connecting to is powered on.
The default IP address must not be occupied by any other
device in the network. Make sure that the default IP
addresses of existing DIVAR IP systems in the network are
changed before adding another DIVAR IP.
Determine whether the initial installation is on a DHCP
network. If not then you must assign valid IP addresses to
the video devices. Consult the local IT administrator to
obtain a valid IP address range to be used with DIVAR IP
and associated devices.
The default iSCSI settings are optimized for use with VRM.
Full video recording and management system, utilizing the
BVMS and VRM core components and services: This mode
allows for advanced video management features such as
event and alarm handling.
Pure video recording system, utilizing the VRM core
components and services.
iSCSI storage expansion for a BVMS or VRM system, which
runs on a different hardware.
System setup | en
2019.08 | V1 | DOC
21