Arming The System; Arming In Away Mode - Bosch AMAX panel 2000 Installation Manual

22 en | User Guide
Zone description
Zone 1 ______________________________________________________
Zone 2 ______________________________________________________
Zone 3 ______________________________________________________
Zone 4 ______________________________________________________
Zone 5 ______________________________________________________
Zone 6 ______________________________________________________
Zone 7 ______________________________________________________
Zone 8 ______________________________________________________
Exit Time ___________________________________________________ sec
Entry Time _________________________________________________ sec
User Code Names
Code 1 _____________________________________________________
Code 2 _____________________________________________________
Code 3 _____________________________________________________
Code 4 _____________________________________________________
Code 5 _____________________________________________________
Code 6 _____________________________________________________
Code 7 _____________________________________________________
Code 8 _____________________________________________________
Code 9 _______________________________________________________Keyfob 1
Code 10 _____________________________________________________ Keyfob 2
Code 11 _____________________________________________________ Keyfob 3
Code 12 _____________________________________________________ Keyfob 4
Code 13 _____________________________________________________ Keyfob 5
Code 14 _____________________________________________________ Keyfob 6
Code 15 _____________________________________________________ Keyfob 7
Code 16 _____________________________________________________ Keyfob 8
4.1

Arming the System

NOTICE!
When the number of incorrect code entries on the keypad reaches a specified number, the
keypad will automatically lock for 180 seconds and alarm is reported.If the keypad is idle for 4
minutes, the system will automatically exit from any operational mode.
4.1.1

Arming in AWAY mode

Arming the system in AWAY Mode is normally performed when you leave the premises and
require that all zones are activated in a ready state to detect an intrusion.
Keypad arming
The system can be set to AWAY mode in two different ways.
To arm the System in AWAY mode (method 1)
Enter your code and press [#].
Two beeps sound, the AWAY indicator flashes slow, and exit time starts. After exit time, the
AWAY indicator turns is lit.
To arm the System in AWAY mode (method 2)
Press and hold [#] until it beeps twice.
F.01U.241.127 | V4 | 2011.12 Installation Manual
AMAX panel 2000 / AMAX panel 2000 EN
Bosch Sicherheitssysteme GmbH